To Next PageTo Next Page
Need help?Do you have a question about the Haworth Hop TS and is the answer not in the manual?
General| Brand | Haworth |
|---|---|
| Model | Hop TS |
| Category | Indoor Furnishing |
| Language | English |
Overheating has caused it to stop the Control Box. Let Control Box cool down.
M1, M2, or M3 internal errors. Pull plug and replace controller box.
M1, M2, or M3 defective. Replace leg/motor.
M1, M2, or M3 over-current. Unload table.
Errors E12, E13, or E14 with no connection. Check connections.
Noise caused by loose hex rod. Tighten hex rod.
Remove obstruction to resolve collision.
Single stage leg calibration is initializing; dual stage leg calibration is initializing.
Max load exceeded indicates an over-current error. Unload table.
Set desired height and press buttons until two clicks are heard.
Press and hold buttons until one click is heard.
Check hand switch for error code and identify column leg and control box.
Swap connectors (M1 & M2) as shown for troubleshooting.
Diagnose bad control box for E12/E24 or bad leg for E13/E25.
Ensure both legs are level before installing gear connector rod.
Adjust and tighten gear connector rod, ensuring full seat.
