What to do if water is leaking from the eyewash heads of my Haws Personal Care Product?
If water is leaking from the eyewash heads, it could be because the water level has exceeded the fill line indicated on the side of the unit; remove excess water until the fill line is reached. Also, ensure the unit is level from front to back and left to right.
How to fix poor flow from eyewash heads in Haws 7501 Personal Care Products?
To fix poor flow from the eyewash head(s), begin by tightening the head assembly. Then, check for any obstructions. If obstructions are found, remove the eyewash head(s), clean them, and reassemble. To reassemble the head, put the cap screw through the head and thread it into the head anchor two or three turns. Tilt the head assembly and work the anchor legs into the eyewash armholes. Tighten the assembly and check for leaks.
Why does the eyewash of my Haws Personal Care Product flow for less than 15 minutes?
The eyewash may flow for less than 15 minutes if the water level in the eyewash tank is not filled to the water fill line indicated on the side of the unit. Fill the water to the indicated line.
What to do if there is a water leak between joints or fittings in my Haws Personal Care Product?
If you notice a water leak between the joints or fittings, pull the hose off the fitting and smooth any raised plastic edges on the center of the fitting. Then, return the hose and hose clamp to their original positions. You may also need to tighten the hose clamp(s) with pliers.
What to do if the heater doesn’t turn on in my Haws Personal Care Product (Model 7501T/7501T240)?
If the heater doesn’t turn on, first check if the unit is plugged in or if there is power to the plug. Check the GFCI and circuit breaker (7501T only). Also, if the ambient temperature is high and doesn’t allow the water temperature to drop below 68°F (20°C), test the thermostat and heater function by applying ice in a circular motion to the thermostat location for approximately 3-5 minutes. The heat trace cable should become warm to the touch when operating properly.
Why is there excessive water loss from my Haws Personal Care Product?
If you observe excessive water loss, check the unit for leaks. Note that some water loss due to evaporation is normal.
Details Haws' warranty for defective material or poor workmanship, excluding consequential damages.
Lists tools for installation and specifies ideal unit placement for accessibility and safety.
Details power requirements, voltage, current, and acceptable operating temperature ranges for models.
Covers blanket installation, unit mounting for different models, and ensuring correct leveling.
Instructions on filling the unit, energizing heated models, and critical electrical safety requirements.
Guides users on how to properly use the eyewash station during an emergency.
Details inspection schedules, preventing bacteria, and procedures for refilling eyewash tanks.
Provides solutions for common issues like no flow, poor flow, leaks, and heater malfunctions.
Itemized list of all replaceable parts with corresponding part numbers for ordering.
General| Model | 7501 |
|---|---|
| Category | Personal Care Products |
| Flow Rate | 0.4 GPM |
| Compliance | ANSI Z358.1 |
| Product Type | Emergency Eye Wash |
| Mounting | Wall Mount |
| Material | Polyethylene |
| Type | Emergency Eyewash |
To Next Page
