1
3
4
2
(5/16")
8mm
– INSTALLATION OF WALL BRACKET –
Make sure you have mounted all connectors
on your profiles before going ahead.
1. Insert the Mounting tool
E
into the
Connector
B on a Profile
A .
2. Make sure it is level, and then make a mark
on the wall, through the small hole in the
Mounting tool
E ..
3. Drill a hole in the wall on your marking.
If you are using the provided wall plugs, use
a 10 mm (5/16˝) drill bit.
4. Identify your wall type. If it is a brick wall or
solid concrete, insert the provided wall plugs
F. .
Other wall types may require other types of
fastening. Consult a professional if in doubt.
5. Line up the Wall bracket
H and fasten it with
a Screw
G . Do not tighten the screw completely.
6. Make sure the Wall bracket is level, then mark
where to drill the next hole.
7. Move the wall bracket to the side and drill
a hole on your marking.
10
To Next Page
