9 11
8
10
8. Slide the Mounting tool
E. into the top
connector of the middle profile.
9. Go back to pages 1011 and follow the
instructions to mount the next wall bracket.
10. Slide the next two shelves into the
connectors in the profiles. Make sure the
connectors on the back of the top shelves
go into the designated cut-outs on the wall
bracket.
11. Finally you can adjust the height of the feet
of your shelving by first loosening the nut right
under the profile. Use the provided Wrench
Q .
Then turn the glider to bring it up or down.
Tigthen the nut when you have reached the
desired hight.
1918
To Next Page
Loading...
