35
Problem: The modem speaker volume is too low or too
high.
Solution:
Your modem has a small speaker on board that
provides audible feedback of dial tones and remote
connection signals (“handshaking”). This is not the
same as the speaker that you may have connected
to your sound card.
If the software allows you to control the volume,
make sure the speaker is enabled and set to a
comfortable volume.
If the software does not have speaker settings, add
one of the AT commands listed below to the
initialization string:
L1 for low volume
L2 for medium volume
L3 for highest volume
M0 to turn the speaker off entirely
For example, if you want the volume low and the
software uses the initialization string AT &F, change
it to AT &F L1.
To Next Page
Loading...
