Why won't my Hayter Harrier 41 self propel (Autodrive Only)?
If your Hayter Lawn Mower (Autodrive Only) won't self-propel, the clutch may be out of adjustment or the drive belt could be damaged. You can adjust the clutch cable or replace the drive belt.
How to fix an uneven cut with my Hayter Harrier 41 Lawn Mower?
An uneven cut with your Hayter Lawn Mower can be caused by undulating ground conditions, a worn cutterblade, an out-of-balance cutterblade, or damaged wheels/roller. To address this, try changing the direction of travel, sharpen the cutterblade, balance the cutterblade, or inspect and replace the wheels/roller as necessary.
Why my Hayter Lawn Mower engine will not start?
If your Hayter Lawn Mower engine will not start, several factors could be at play. Ensure the engine isn't under load by raising the height of cut. Check for and correct incorrect or contaminated fuel. Make sure the spark plug lead is connected, the engine brake is released, and the fuel shutoff valve is in the 'ON' position. Also, inspect the spark plug for faults and check the wiring.
What to do if Hayter Harrier 41 Lawn Mower has excess oil level?
If the oil level is too high or the air cleaner cartridge is oil soaked or blocked in your Hayter Lawn Mower, take these steps: * Check the oil level and correct if necessary. * Service the air cleaner.
What to do if Hayter Lawn Mower is not discharging grass properly?
If your Hayter Lawn Mower experiences issues with grass discharge, several factors could be responsible. These include restricted airflow through the grassbag, a blocked discharge chute, wet grass, a full grassbag, or an engine speed that is too slow. Consider the following solutions: * Clean the grassbag to ensure proper airflow. * Remove any blockage from the discharge chute. * Mow only when the grass is dry. * Empty the grassbag regularly. * Ensure the engine speed is set to fast by adjusting the throttle.
Why is my Hayter Harrier 41 Lawn Mower not collecting grass?
If your Hayter Lawn Mower is not collecting grass properly, it could be due to several reasons: the grass might be wet, the cut height may be too low, the grassbag could be full, the airflow through the grassbag might be restricted, or the engine speed could be too slow. Here’s what you can do: * Mow dry grass. * Increase the cut height. * Empty the grassbag. * Clean the grassbag to improve airflow. * Set the throttle to the fast position to increase engine speed.
Why is my Hayter Lawn Mower cutting unevenly?
If your Hayter Lawn Mower is leaving an uneven cut, consider these possibilities: the ground may be undulating, the cutterblade could be worn or out of balance, or the wheels/roller might be damaged. To resolve this: * Try changing the direction of travel. * Sharpen the cutterblade. * Balance the cutterblade. * Inspect the wheels/roller and replace them if necessary.
What to do if cutterblade drive will not engage on Hayter Harrier 41?
If the cutter blade drive on your Hayter Lawn Mower will not engage, make sure the engine stop lever is pushed fully forward to engage.
What to do if Hayter Lawn Mower has poor grass collection?
If you're experiencing poor grass collection with your Hayter Lawn Mower, consider the following: * The airflow through the grass bag might be restricted. Clean the grass bag. * The discharge chute could be blocked. Remove any blockage. * The grass may be wet. Mow in dryer conditions. * The grass bag might be full. Empty the grass bag.
What to do if Hayter Harrier 41 engine will not turn over?
If the engine of your Hayter Lawn Mower will not turn over, ensure the engine stop lever is operated. Check the oil level and correct it if it's incorrect. Also, remove any obstruction under the deck.
General| Cutting Width | 41 cm |
|---|---|
| Engine Type | Petrol |
| Drive System | Self-propelled |
| Cutting Height | 13 - 60 mm |
| Deck Material | Aluminium |
| Starting System | Recoil |
| Engine | Briggs & Stratton |
| Roller | Yes |
| Grass Collector Capacity | 45 L |
| Wheel Size | 7 inch |
Guidance on proper training and familiarization with mower controls.
Pre-operation checks and safety measures before using the mower.
Safe operating procedures and precautions to follow during mowing.
Explanation and location of various warning and information decals on the mower.
Identification of components for the general assembly of the mower.
Instructions for unpacking and assembling the new mower.
Essential checks and preparations before starting the engine.
Detailed steps for starting the mower's engine using different methods.
Procedures for safely stopping the mower's engine, including emergency stops.
How to adjust the cutting height for optimal mowing.
Instructions for moving the mower forwards and in reverse.
Techniques for making wide and tight turns with the mower.
Guidance on attaching, using, and emptying the grassbag.
Instructions for mowing without collecting grass clippings.
Tips for mowing areas with heavy grass growth.
Procedure for moving the mower over surfaces other than grass.
Information and warnings regarding the operation of the cutterbar.
Advice on effective mowing techniques and lawn care.
Essential engine maintenance including oil, air, spark plug, and carburettor.
Procedure for adjusting the throttle cable for optimal performance.
Information on carburettor adjustments, recommended for dealers.
Instructions for checking, draining, and changing engine oil.
Steps for cleaning or replacing the air cleaner cartridge.
Guidance on checking and replacing the spark plug.
General cleaning of engine, grassbag, and deck housing.
Regular checks to ensure all nuts and bolts are tight.
Lubrication points and schedule for the mower's moving parts.
Procedure for adjusting the clutch cable on Auto Drive models.
Procedures for cutterbar care, sharpening, and safety.
Instructions for charging the battery on electric start models.
Initial maintenance steps required after the first 5 hours of operation.
Daily or every 5-hour checks and cleaning procedures.
Maintenance tasks to be performed every 25 hours or seasonally.
Maintenance tasks to be performed every 50 hours or seasonally.
Maintenance tasks to be performed every 100 hours or seasonally.
Diagnosing and resolving issues when the engine fails to turn over.
Identifying causes and solutions for engine smoking issues.
Troubleshooting why the engine starts and then stops.
Common reasons and remedies for the engine failing to start.
Diagnosing and fixing issues causing the engine to run unevenly.
Addressing causes of excessive vibration in the engine.
Troubleshooting causes for an uneven cut pattern.
Resolving blockages in the grass discharge chute.
Identifying reasons why the mower is difficult to push.
Troubleshooting why the mower's self-propel function is not working.
Diagnosing and fixing issues leading to poor grass collection.
To Next Page