What to do if my Hayter Harrier 56 will not self propel?
If your Hayter Lawn Mower is not self-propelled, the clutch may be out of adjustment, so adjust the ground drive clutch cable. Also, the drive belt may be damaged, so replace it.
Why does my Hayter Lawn Mower have an uneven cut?
If your Hayter Lawn Mower is giving an uneven cut, it could be due to undulating ground contours, so change the direction of travel. The cutterblade might be worn, so sharpen it or out of balance, so balance the cutterblade. Damaged wheels or rollers could also be the cause, so inspect and replace them as necessary.
What to do if the discharge chute blocks on my Hayter Lawn Mower?
If the discharge chute of your Hayter Lawn Mower is blocked, it could be due to several reasons. The grass might be wet, so try mowing when the grass is dry. The cut height might be too low, so increase it. The grassbag could be full, so empty it. The engine speed might be too slow, so increase it. Also, airflow through the grassbag might be restricted, so clean the grassbag.
Why is my Hayter Lawn Mower hard to push?
If your Hayter Lawn Mower is hard to push, it might be because the cut height is too low, so increase it. Another reason could be damaged wheels or rollers, so inspect and lubricate or replace them as necessary.
How to fix excessive vibration in my Hayter Harrier 56 engine?
If your Hayter Lawn Mower engine vibrates excessively, check the following: * Tighten any loose mounting bolts. * Tighten any loose cutterblade screws. * Balance the cutterblade. If the crankshaft is bent, consult your dealer.
Why does my Hayter Harrier 56 engine vibrate excessively?
Excessive vibration in your Hayter Lawn Mower's engine can stem from loose mounting bolts or cutterblade bolt, an unbalanced cutterblade, or a bent crankshaft. To address this, tighten the bolts, balance the cutterblade, or consult your dealer.
How to fix an uneven cut with my Hayter Lawn Mower?
An uneven cut with your Hayter Lawn Mower can occur due to undulating ground conditions, a worn or unbalanced cutterblade, or damaged wheels/roller. To fix this, change the direction of travel, sharpen or balance the cutterblade, and inspect and replace the wheels/roller as necessary.
Emphasizes reading the handbook for safety and operation.
Covers general safety, operation, maintenance, fuel, and storage guidelines.
Explains warning decals and identifies control labels.
Lists mower model, engine, dimensions, and weight.
Advises safety, lists components, and guides initial setup and control checks.
Details pre-start checks for oil/fuel and the engine starting procedure.
Procedures for normal and emergency engine shutdown.
Covers height adjustment, travel, mowing techniques, and cutterblade use.
Covers safety, engine service, cutterblade maintenance, and storage prep.
Solutions for engine, mowing, and drive system performance issues.
Comprehensive parts list and diagram for component identification.
Lists and illustrates common engine service parts like fuel additive and spark plugs.
Covers terms, conditions, and warranty periods for Briggs & Stratton engines.
Manufacturer's compliance statement and measured vibration data.
General| Cutting Width | 56 cm |
|---|---|
| Drive System | Self-propelled |
| Cutting Height Range | 13 - 60 mm |
| Grass Bag Capacity | 70 litres |
| Roller | Yes |
| Engine Power | 190 cc |
| Cutting Height Adjustment | Single lever |
| Deck Material | Aluminum |
| Warranty | 5 years (conditional) |
| Engine Type | Briggs & Stratton 850E I/C OHV |
To Next Page