Hayward Super II User Manual

WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
P/N: IS3000XAZ-05
Rev. C
__________________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
*50HZ Models are not UL or CSA Listed.
Super II
™
Pump Series
The Hayward Super II Pump is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that
is equipped with large capacity filters, heaters, and pool cleaning equipment. The Super II is a self-priming pump that incorporates an
improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service. The advanced design
provides superior performance while reducing maintenance requirements.
To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.
WARNING – This product should be installed and serviced only by a qualified professional.
CAUTION – A licensed electrician MUST complete, in full, all electrical installations noted in this manual.
SAVE THIS INSTRUCTION MANUAL
Use of non-Hayward replacement parts voids warranty.
ATTENTION
INSTALLER – THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE
INSTALLATION,
OPERATION, AND SAFE USE OF THIS PUMP THAT MUST BE FURNISHED TO THE END USER
OF THIS PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY.
HAYWARD POOL PRODUCTS, INC.
620 DIVISION STREET ELIZABETH, NJ 07207 (908) 351-5400
WWW.HAYWARDPOOL.COM

Hayward Super II Specifications

General

Voltage	115/230V
Port Size	2 inches
Wet End Material	Thermoplastic
Seal Type	Mechanical
Connection Size	2 inches

Summary

Hayward Super II Pump Series Overview

Product Introduction and Features

Overview of the Hayward Super II Pump Series and its key benefits.

Important Safety Instructions

Understanding Safety Alerts

Explanation of safety symbols and signal words used in the manual.

General Pool Equipment Safety

Essential safety guidelines for operating and supervising pool equipment.

Electrical Safety and Entrapment Prevention

Electrical Shock Hazard Mitigation

Critical warnings and procedures for preventing electrical shock.

Preventing Suction Entrapment

Detailed explanation of entrapment hazards and preventative measures.

Operational Hazards and Product Benefits

Pressure and Separation Hazard Warnings

Alerts regarding hazardous pressure and potential component separation.

Hayward Super II Pump Benefits

Highlights of the pump's design advantages and performance features.

Installation and Specifications

Pump Location and Mounting Guidelines

Recommendations for optimal pump placement and secure mounting.

Pipe Sizing and Flow Rate Chart

Chart showing recommended flow rates based on pipe diameter.

Plumbing and Electrical Setup

Plumbing Connection Best Practices

Guidance on plumbing connections, fittings, and sealant use.

Electrical Grounding and Bonding

Essential instructions for grounding and bonding the motor for safety.

Electrical System Requirements

Voltage and Wiring Standards

Specifications for motor voltage, wire size, and electrical code compliance.

GFCI Protection and Wiring

Requirements for GFCI installation and proper circuit wiring.

Pump Operation and Maintenance

Pre-Operation Checks

Steps to perform before starting the pump for the first time.

Routine Pump Maintenance

Guidelines for cleaning and maintaining the pump's components.

Storage, Winterization, and Seals

Pump Storage and Winterization

Procedures for protecting the pump during off-season or freezing conditions.

Shaft Seal Replacement Guide

Detailed instructions for replacing the pump's shaft seal assembly.

Component Disassembly and Reassembly

Impeller and Seal Plate Removal

Step-by-step guide for removing the impeller and seal plate.

Reassembling Impeller and Motor

Instructions for correctly reassembling the impeller, diffuser, and motor.

Replacement Parts Identification

Pump Parts Diagram

Visual representation of pump components with labels.

Detailed Parts Listing

Comprehensive list of part numbers for different pump models.

Troubleshooting Guide

Motor and Priming Issues

Solutions for motor start failures, shutdowns, and priming problems.

Suction and Air Leak Diagnosis

Identifying and resolving issues related to suction and air leaks.

Pump Performance Issues

Diagnosing Low Flow

Troubleshooting steps for addressing reduced water flow.

Resolving Pump Noise

Identifying causes of pump noise and methods for correction.

Warranty and Registration

Hayward Limited Warranty Policy

Details of the warranty coverage and exclusions.

Product Warranty Registration

Instructions for completing and submitting the warranty registration card.