Page 4 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
GENERAL INFORMATION
Your Hayward SwimClear
TM
cartridge filter combines superior water filtration with ease of operation and totally
corrosion-free construction. With filtration ratings to 9000 gallons (34,000 liters) per hour, they are designed for
continuous or intermittent operation, for installation above or below the pool water line, for fresh or salt water swimming
pools or spas. SwimClear™ filters utilize multiple reusable, reinforced polyester filter cartridge elements to provide a
high degree of water clarity and long filter cycles with minimum care.
REQUIRED CLEARANCE
A
“B” SIDE “C” ABOVE
IN CM IN CM IN CM
C2025 32.5 83 18 46 15 38
C3025 34.5 88 18 46 16 41
C4025 40.5 103 18 46 18 46
C5025 46.5 118 18 46 22 56
C7000 52.5 133 18 46 28 71
INSTALLATION
WARNING
This product should be installed and
serviced only by a qualified pool professional.
1. The filter system should be installed
on a level concrete slab or other rigid
base. Select a well drained and
vented area, one that does not flood
when it rains. Position the filter so
that the piping connections, and
winter drain are convenient and
accessible for operation, service,
maintenance and winterizing.
2. Position filter body such that all
operation and safety labels are
visible.
3. Position filter so the filter will drain by
gravity.
4. If practical, place pump and filter in
the shade to shield it from continuous,
direct heat from the sun.
5. Connect the pool suction plumbing
between the skimmer, pool outlet
(from the pool) and the pump.
6. Install the plumbing from the filter to
the pool (return to the pool).
7. Do not locate pump controls over or
near filter.
8. Verify water discharge from the
manual air relief valve(MAR) is
directed away from electrical devices.
B
To Next Page
Loading...
