What to do if some commands are not carried out by HBC-Radiomatic Remote Control?
If some commands are not being carried out by your HBC-Radiomatic Remote Control, it could be due to a defective receiver or an interruption in the connecting cable to the crane or machine. Check that all connecting cables and cable junctions are tight to ensure proper communication.
What to do if HBC-Radiomatic FSE 511 Remote Control transmitter does not react when switched on?
If your HBC-Radiomatic Remote Control transmitter doesn't react when switched on, it may be due to a lack of power. First, check the battery contacts for any signs of damage or contamination. Next, ensure a fully charged battery is properly inserted into the battery compartment. If the issue persists, try recharging the battery.
General| Brand | HBC-Radiomatic |
|---|---|
| Model | FSE 511 |
| Category | Remote Control |
| Language | English |
To Next Page
