HBC FSE 514 - Automatic HOLD Function Settings (Eltako)

Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB Page 13 / 18
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifications subject to change without notice. 30-04-2003
Radio System
3.2 Automatic HOLD Function Settings (Eltako)
The automatic HOLD function of relay K12 can be activated or deactivated
(latched/unlatched) with switches S2 and S3 on the relay board.
For example, the relay can be used together with the "Light" function (remote control
circuit).
! The automatic HOLD function is activated (latched) when switches S2 und S3 are
set to position II.
! The automatic HOLD function is deactivated (unlatched) when switches S2 und S3
are set to position I.