Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB Page 15 / 18
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifications subject to change without notice. 30-04-2003
Radio System
5 Maintenance
The radio receiver is virtually maintenance-free. However, the following points should be
taken into consideration :
! Never use a high-pressure cleaner or steam jet cleaner to "clean" the receiver.
! Whenever welding the crane or machine:
− Switch OFF the radio control system.
− Switch OFF the crane or machine.
− Disconnect receiver connection cable.
Failure to observe these precautions will cause severe damage to the radio control
system.
Note:
In the event of any problems with the radio control system, contact your local distributor
or HBC-radiomatic GmbH.
5.1 In The Event of a Fault
Warning:
Never operate a crane or machine with a faulty or defective radio control system.
! Never try to repair the radio receiver electronics! Opening the transmitter housing
terminates the manufacturer guarantee.
– Send any defective or faulty equipment to your local distributor or to the
manufacturer. They are experts and have the necessary know-how and OEM
spare parts.
– Always send transmitter and receiver and enclose a detailed description of the
problem.
– Do not forget to enclose your address and telephone number so that we can get
in touch with you quickly if necessary.
! To avoid damage during transport, use the original packing supplied with the
transmitter and receiver, otherwise pack securely. Send the consignment to your
distributor or to the following address :
HBC-radiomatic GmbH
Haller Strasse 49 – 53
74564 Crailsheim
Germany
! Should you chose to deliver a defective radio control system personally to your
distributor or our factory, please call and arrange an appointment.
HBC-radiomatic GmbH
– Customer Services / Repair Service –
Tel.: +49 ( 0 ) 79 51 – 3 93 – 800
To Next Page
