healing HHT896 HD Digital Terrestrial Receiver Operating Manual
REAR PANEL
1. ANTENNA LOOP OUT: passes antenna signal to another receiver,
Antenna Loop Out becomes idle when receiver on STANDBY!
2. ANTENNA IN: connect your antenna, essential for stable pictures.
3. COMPONENT VIDEO: Y,Pb,Pr outputs for high picture quality.
4. AUDIO Right and Left Outputs.
5. VIDEO: Composite CVBS or lesser quality picture output.
6. SPDIF: Digital Audio Toslink output for superior audio quality.
7. HDMI: digital Video and Audio output, combined over a single cable.
8. USB: connect a USB Key or Hard Disk Drive for recording, replay
or in the unlikely event firmware upgrade is necessary.
9. Mains power connection: IEC C7 2 wire connector.
7
To Next Page
Loading...
