EasyManua.ls Logo

Healthy Climate Solutions HCWHD4-100 User Manual

Default Icon
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
Safety Instructions
WARNING
1. 120 Volts may cause serious injury from electric
shock. Disconnect electrical power before starting
installation or servicing. Leave power disconnected
until installation/service is completed.
2. Sharp edges may cause serious injury from cuts. Use
care when cutting plenum openings and handling
duct system.
3. Dropping may cause personal injury or equipment
damage. Handle with care and follow installation
instructions.
CAUTION
1. Read all instructions before beginning installation.
2. Improper installation may cause property damage or
injury. Installation, service, and maintenance must be
performed by a qualied service technician.
3. Do not use in pool applications. Pool chemicals can
damage the dehumidier.
4. Do not use solvents or cleaners on or near the circuit
board. Chemicals can damage circuit board components.
5. Wait 24 hours before running the unit if it was not
shipped or stored in the upright position
6. Do not use dehumidification to prevent window
condensation in the winter. During the winter the
dehumidier does not run enough to effectively prevent
window moisture. The dehumidifier has a 40° dew
point lower limit and the moisture level in a home during
the winter is usually below this value. The window
condensation is a result of the cold outdoor air/window
temperature. Ventilation is the most effective and efcient
means of dealing with window condensation in the winter.
7. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
8. Children should be supervised to ensure that they
do not play with the appliance.
9. If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
Table of Contents
Safety Instructions ............................1
Specications ................................2
Packaging Content............................2
Set Up Dehumidier for Installation ..............3
Duct Collars ...............................3
Control Location............................4
Location Considerations .......................4
Suspended Installation ........................5
Drain Installation – Model HCWHD4-080
and HCWHD4-100 .............................5
Leveling ..................................6
Drain Installation – Model HCWHD4-130 ..........6
Leveling ..................................6
Condensate Pan, Condensate Pump
and Float Switch..............................6
Ducting to HVAC System – Basement and
Attic Installations .............................7
Ducting for Stand Alone Installations or
Non-Ducted Installations .......................7
Ducting for Two Zone Installations...............8
Lennox Control...............................9
Y6456 – External Control or Crawl
Space/Sealed Attic Control and Wiring ..........10
Wiring the Dehumidier to the HVAC System
and Zone Dampers ...........................11
System Set-up and Checkout ..................12
Installer Test Mode .........................14
Start Up and Sequence of Operation ............15
Single Zone Whole House or Stand Alone
Using the Dehumidier Control ...............15
Single Zone Whole House or Stand Alone
Using an iComfort
®
Thermostat or
Y6456 External Control .....................15
Crawl Space or Sealed Attic (Remote) Control
Using Y6456..............................15
Two Zone – Primary and Secondary ...........15
Ventilation ..................................16
Installation & Wiring ........................16
Vent Auto & Vent-Timed .....................16
Outdoor Temperature Sensor Installation .......17
Determine Ventilation Requirements ...........17
Installer Settings ..........................18
Sequence of Operation .....................19
Troubleshooting .............................19
Table 4 – Error Codes ......................20
Table 5 – Troubleshooting Guide ..............21
Wiring Schematic ............................22
Service Parts................................23
DEHUMIDIFIERS
508165-01
3/2021
Supersedes 507386-02
HEALTHY CLIMATE
®
DEHUMIDIFIERS
INSTALLATION INSTRUCTIONS FOR HEALTHY CLIMATE
®
DEHUMIDIFIER
MODEL HCWHD4-080, HCWHD4-100 AND HCWHD4-130
READ COMPLETE SAFETY INSTRUCTIONS AND INSTALLATION INSTRUCTIONS BEFORE STARTING
Question and Answer IconNeed help?

Do you have a question about the Healthy Climate Solutions HCWHD4-100 and is the answer not in the manual?

Healthy Climate Solutions HCWHD4-100 Specifications

General IconGeneral
ModelHCWHD4-100
Energy Star RatedYes
Control TypeDigital
Weight92 lbs
Dimensions25.5 x 15.0 x 17.0 inches
Airflow235 CFM
Voltage115V
Power Supply115V, 60Hz

Summary

Safety Instructions

WARNING

Critical safety warnings regarding electrical shock, sharp edges, and dropping hazards.

CAUTION

Important precautions for installation, including electrical safety, chemical damage, and proper handling.

Installation Setup Procedures

Shipping Bracket Removal

Instructions for removing the shipping bracket and strap securing the compressor before installation.

Drain Installation and Management

Drain Installation (Models HCWHD4-080/100)

Instructions for hard piping the drain outlet for HCWHD4-080 and HCWHD4-100 models.

Drain Trap and Insert Precautions

Requirements for drain trap installation and warnings regarding the drain insert's critical function.

Unit Leveling and Condensate Handling

Drain Installation (Model HCWHD4-130)

Instructions for hard piping the drain outlet for the HCWHD4-130 model.

Ducting to HVAC System

Basement and Attic Ducting

Preferred installation method for ducting to the HVAC return, ensuring proper air mixing.

Two-Zone Ducting Configuration

External Control Integration (Lennox)

Y6456 Control Integration and Wiring

Wiring the Dehumidifier to HVAC and Zone Dampers

Installer Setup and Checkout

System Setup Navigation

Guide to navigating the on-board control for initial setup and configuration.

Advanced Configuration Settings

Installer Test Mode Operation

Test Mode Procedures

Procedure for entering and running the installer test mode to verify system operation.

Start-Up and Sequence of Operation

Ventilation Functionality and Installation

Calculating Ventilation Requirements

Determining Cycle Time and Installer Settings

Installer Settings for Ventilation

Steps to select and enable ventilation modes (Timed or Auto) through the installer settings menu.

Sequence of Operation Details

Troubleshooting Introduction

Introduction to troubleshooting, error codes, and contact information for technical support.

Error Code Reference

All Error Codes (E1-E9)

Comprehensive list of error codes, failure modes, actions, and reset procedures for system faults.

Troubleshooting Guide

Unit Operation Troubleshooting

Solutions for common issues like unit not running, airflow problems, or compressor issues.

Damper and Drainage Troubleshooting

Addressing problems with damper operation and improper unit drainage.

Wiring Schematic

Dehumidifier Internal Wiring Diagram

Detailed schematic illustrating the internal wiring connections of the dehumidifier's components.

Related product manuals