Hearth & Home Technologies • Grand Oak Hearth Kits • 4004-323 Rev E . 4/2020
10
Cleaning
• Periodic examination and cleaning of the venting system
of the replace should be done before initial use and at
least annually by a qualied agency.
Do not allow soot to build up on the logs
Your logs require little care. Keep the burner assembly, logs
and burner area surrounding the logs clean by brushing
with a dry paint brush at least twice a year.
• Always turn o the gas to the pilot before cleaning. For
relighting, refer to Section N. Lighting Instructions.
• Always keep the appliance clean and free from
combustible materials, gasoline and other ammable
vapors and liquids.
• Never obstruct the ow of combustion and ventilation air.
Keep the front of the appliance clear of all obstacles and
materials.
• Leave clearance of at least 36 in. from the front of the
replace.
• The air shutter should not be blocked.
Before cleaning the appliance, be sure it is turned
completely o. The pilot should also be turned o. The
unit must be completely cooled.
CAUTION
After burning, the logs become fragile. Take care in
handling.
CAUTION
M. Cleaning and Maintenance Instructions
Always remember:
• Do not place any combustible material near the
appliance.
• Do not place any paper, trash or other material on the log
set or in the replace.
• Do not touch any part of the appliance when it is in
operation.
• Do not operate this appliance without the replace screen
closed.
Your appliance is designed to be virtually maintenance free,
although periodic visual inspection and cleaning is required.
Follow the instructions below for the correct procedures. An
annual examination and cleaning the venting system by a
qualied person is also recommended.
To Next Page
Loading...
Need help?
General
