Assembly 4
UNPACKING AND INSPECTION
Packing List
1 - Tucson Gas-fired Heater
4 - Decorative Ceramic Fiber Logs
1 - Ember Screen
1 - Thermostat with 40' Thermostat Wire
1 - Owner’s Manual
1 - Warranty Validation Form
1 - Bag Charcoal Embers (2oz)
Unpack and Inspect For Damage
The Tucson is packaged by the manufacturer to
withstand shipment without damage under most
circumstances. However, damage can occur
during transit and handling, so take care to
inspect for damage when unpacking and
installing the unit. If any damage or missing
parts are detected, immediately contact your
dealer. Do not install or put into service a
damaged or incomplete heater.
Prior to removing the shipping carton, inspect
the carton for visible signs of damage. Carefully
remove the shipping carton. Caution: The two
top stones and grill are NOT cemented or
otherwise permanently fastened in place!
Carefully remove and set aside the two stones
and grill. Use the protective wrapping material
to temporarily protect the stones from chipping
and damage while the unit is inspected and
installed.
Inspect the Tucson for visible or concealed
damage. The unit should appear to be square
and true. The stones should be whole and
without cracks, chips or breakage. The sheet
metal parts should be smooth and free of bends
or dents. The enameled cast iron should be free
of chips or cracks. If visible or concealed
damage is found or suspected, contact your
dealer for instructions.
With the top stones and grill removed and set
aside, undo the lag bolts which fasten the unit to
the pallet. Take care not to mar or chip the
enameled legs (if stove is enameled). Lift the
stove off the pallet and set it into place.
The decorative ceramic fiber logs supplied with
the Tucson are contained within the firebox.
Always use great care when handling the
decorative ceramic fire logs as they are fragile
and subject to damage and breakage if handled
roughly. Open the firebox door using a Phillips
head screw drive and inspect the logs for
breakage. If a broken log is encountered,
contact your dealer for replacement logs.
Otherwise, set the logs aside until called for in
the installation procedure.
ITEMS REQUIRED FOR
INSTALLATION
Ensure that the following items are available
before proceeding with installation:
* External regulator (for propane/L.P.G.
only)
* Piping which complies with local codes
* Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur
compounds)
* Manual shutoff valve
* Sediment trap
To Next Page
Loading...
Need help?
General
