HeartWork Manager Key - Key and User Management; Add Black Manager Keys; Lost or Stolen User Credential; Express User Code Erase

Made (Well)
in the USA
4
heartwork.com 29 West 30th Street Suite 301 New York NY 10001 +1 888 749 7003
LOST OR STOLEN USER CREDENTIAL/ERASE AN ASSIGNED USER CODE
• Press
C
5 5
. The LED will flash
• Touch a registered Black Manager Key to the key slot until a two tone beep is heard.
• While the LED is on, touch the Black Manager Key to the key slot until a three set of two tone beeps are
heard and the LED turns off.
• All previously assigned Assigned User Codes will no longer operate this singular lock.
The lock will still remain in Assigned Use Mode.
To assign a new User code, follow instructions under Part Two–B.
EXPRESS ERASE:
To perform the above operation on multiple locks, continue with below instructions:
• Continue with the single lock that has already had the Assigned User Code erased.
• Press
C
6 6
. The LED will flash.
• Touch the Yellow Programming Key to the key slot.
A two tone beep should be heard and the LED will turn off.
• Move to next lock. Touch the Yellow Programming Key to the key slot until two sets of two tone beeps are
heard and the LED flashes once. This will indicate a success.
• Continue with all locks that you wish to erase.
• Finish this process by going to any lock on which User Codes have been erased. Press
C
🗝.
Then touch the Yellow Programming Key to the key slot.
• Any locks that have undergone this process are now erased. The locks will still remain in Assigned Use Mode.
To assign a new User Code, follow instructions under Part Two–B.
ADD BLACK MANAGER KEYS AFTER INITIAL PROGRAMMING
Black
Manager Keys can be added at any time.
1.
Go to the first lock that requires the pairing of a Black Manager Key.
2.
Press . The LED will start flashing.
3. While the LED is flashing, insert the Yellow Programming Key. A two-tone beep will be heard.
4. While the LED is flashing, insert each additional Black Manager Key one at a time. A beep will be heard
for each Black Manager Key programmed.
5. Insert the Yellow Programming Key. A two-tone beep will be heard and the LED will turn off. Repeat the
above steps for each lock or follow the instructions to Express Key Registration to quickly program
multiple locks to operate with the same Black Manager Key(s).
C
5 5