Heat Controller BG-101G - To Change Temperature Setting; To Adjust Fan Speeds

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual
6
6
AIR CONDITIONER FEATURES(CONTINUED)
TO TURN UNIT ON:
NOTE: The following instructions represent the Unit Controls, the same instructions can be used
for the Remote Control.
TO CHANGE TEMPERATURE
SETTING:
Press the On/Off button.
DO THIS:
Press to lower
DO THIS:
Press to raise
Press or hold either Up( ) or Down ( ) button
until the desired temperature is seen on the
display. This temperature will be automatically
maintained anywhere between 62 F(17 C) and
86 F(30 C). Except under Heating mode, the
temperature is adjustable between
.If you want the display to read
the actual room temperature, see To Operate
on Fan Only section.
60 F(16 C)
and 90 F(32 C)
NOTE:
TO ADJUST FAN SPEEDS:
Press to select
appropriate fan
speed
DO THIS:
Used to select the Fan Speed in four steps-
Auto, Low, Med or High. Each time the button
is pressed, the fan speed mode is shifted.
NOTE:
Temp
Timer Check
Filter
High Med
Follow
Me
Auto Low
Fan
On/Off
Sleep Timer
Temp Temp
Timer
High Med
Timer
On Off
Follow
Me
Auto Low
Fan
Sleep Timer
Temp Temp
Timer
High Med
Timer
On Off
Follow
Me
Auto Low
Fan
Clean
Air
Used to select the Fan Speed in four steps-Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is shifted. If Auto mode is
selected, the fan mode is automatically controlled.
(See “To Select the Operating Mode” section for
more information on this feature.)