Heat Controller BG-81G - Trim Frame and Sealing

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual
22
FINISHINGINSTALLATION:
1.Installthe1x1x84longstuffer-sealbetween
thewall-sleeveandtheunit. A flat-bladed
screwdriverorputtyknifeisrecommended.
1
/
2
2. Assemblethetrimframebyinsertingtopand
bottompiecesintosidepiecesandsnapping
intoplace.
3.Pullcordthroughtrimframethenslideover
unituntilflushwithwall.
21
FINISHINGINSTALLATION:
1.Installthe1x1x84longstuffer-sealbetween
thewall-sleeveandtheunit. A flat-bladed
screwdriverorputtyknifeisrecommended.
1
/
2
2. Assemblethetrimframebyinsertingtopand
bottompiecesintosidepiecesandsnapping
intoplace.
3.Pullcordthroughtrimframethenslideover
unituntilflushwithwall.
22
FINISHINGINSTALLATION:
1.Installthe1x1x84longstuffer-sealbetween
thewall-sleeveandtheunit. A flat-bladed
screwdriverorputtyknifeisrecommended.
1
/
2
2. Assemblethetrimframebyinsertingtopand
bottompiecesintosidepiecesandsnapping
intoplace.
3.Pullcordthroughtrimframethenslideover
unituntilflushwithwall.
22
FINISHINGINSTALLATION:
1.Installthe1x1x84longstuffer-sealbetween
thewall-sleeveandtheunit. A flat-bladed
screwdriverorputtyknifeisrecommended.
1
/
2
2. Assemblethetrimframebyinsertingtopand
bottompiecesintosidepiecesandsnapping
intoplace.
3.Pullcordthroughtrimframethenslideover
unituntilflushwithwall.
22