Need help?Do you have a question about the Heat Controller COMFORT-AIRE RG-51-5 and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Operating Voltage | 115V |
| Operating Frequency | 60Hz |
| Air Flow (High) | 130 CFM |
| Noise Level | 52 dB |
| Coverage Area | 150 sq. ft. |
| Model | RG-51-5 |
| Cooling Capacity | 5000 BTU |
Crucial safety advice for the installation phase to avoid hazards.
Essential safety measures for operating the unit to prevent accidents and damage.
Explains symbols used throughout the manual to convey important information.
Provides the external physical measurements of the air conditioner unit.
Guidance on choosing the optimal placement for the air conditioner for performance and safety.
Step-by-step instructions for mounting the air conditioner in a window.
Lists and describes the components included in the installation kit.
Procedures to perform before the main installation, including panel and seal strip setup.
Initial steps for physically placing and securing the unit in the window.
Detailed steps for carefully lifting and positioning the unit into the window opening.
Instructions on how to properly attach and secure the drain pipe for water removal.
Highlights the main functionalities and design aspects of the air conditioner.
Procedure for testing the unit's electrical insulation resistance.
Explains how to use the various controls and settings of the air conditioner.
Steps for disassembling mechanical components like the grille, cabinet, and control panel.
Procedures for removing air guide, fan, and orifice components.
Instructions for removing electrical components like overload protectors and the compressor.
Steps for disassembling components within the refrigeration system, such as condenser and evaporator.
Visual representation of the electrical connections and components within the unit.
Detailed schematic of the air conditioner's electronic control system and its components.
Identifies the physical placement of components on the main Printed Wiring Board (PWB).
Illustrates the refrigeration piping and component functions for troubleshooting.
Provides a flowchart to diagnose and resolve ineffective cooling issues.
Offers a flowchart to diagnose and resolve unit start-up failures.
Guides through troubleshooting electrical component issues using a flowchart.
Details troubleshooting steps for compressor operational problems.
Outlines steps to diagnose and fix fan operation issues.
Addresses issues with the remote controller and abnormal display on the P.W.B.
Troubleshooting voltage limits and operational issues for the fan motor.
Addresses fan motor noise, compressor not running, and overload cycles.
Diagnoses insufficient cooling, excessive noise, and compressor overload conditions.
To Next Page