Need help?Do you have a question about the Heat Controller GeoLogix HTS Series and is the answer not in the manual?
General| Cooling Capacity | 18, 000 - 60, 000 BTU/h |
|---|---|
| Refrigerant | R-410A |
| Heating Capacity | 18, 000 - 60, 000 BTU/h |
| HSPF | Up to 10.0 |
| Operating Temperature Range (Heating) | Down to -13°F (-25°C) |
Explains the meaning of each code in the model number.
General and specific safety guidelines for installation and operation.
Critical procedures for evacuation and charging.
Key diagnostic procedures.
Overview, compatibility, configuration, and startup.
Pre-power checks before operation.
Step-by-step guide for initial operation.
General advice and DXM2 diagnostics.
Using service mode and configuring options.
A visual guide to diagnosing DXM2 issues.
Diagnosing power, pressure, and charge issues.
Troubleshooting low temp limits for water and air.
Diagnosing condensate and voltage issues.
Issues with unit performance and components.
Troubleshooting IFC, no fault, short cycles, and fan-only modes.
Diagnosing low cooling/heating output and airflow.
Addressing high head pressure, low suction, and humidity.
Troubleshooting operational failures and valve problems.
To Next Page