Heath Zenith SL-5525 User Manual

© 2004 DESA Specialty Products™ 595-5295-11
1 Halogen
Lamp
Sensor
Light Control
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Motion Sensing
Halogen Fixture
Model SL-5525
3 Wire
Connectors
6 Screws
(3 sizes included)
Gasket
Mounting Bolt
Mounting Strap
OPERATION
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
TEST
... back on.
AUTO
1 Second OFF
then...
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switch Summary
Flip light switch off
for one second
then back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Light Shield
Plastic Hanger
Rubber Plug
Mode: On-Time: Works: Day Night
Test 5 Sec x x
Auto 1, 5, 10 min. x
Manual Until Dawn* x
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Put the ON-TIME switch in the 1, 5,
or 10 minute position.
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
This package includes:

Heath Zenith SL-5525 Specifications

General

Brand	Heath Zenith
Model	SL-5525
Category	Light Fixture
Language	English

Summary

Motion Sensing Fixture Operation

Operating Modes Explained

Details the TEST, AUTO, and MANUAL operating modes and their functions.

Package Contents

Lists all components included in the fixture package for installation.

Installation System Requirements

Outlines the electrical and environmental requirements for the fixture.

Fixture Installation Guide

Bulb Replacement Procedure

Step-by-step instructions for safely replacing the halogen bulb.

Wiring and Electrical Connections

Guide to connecting the fixture's wires to the junction box.

Mounting the Light Control

Instructions for securing the fixture's cover plate and gasket.

Test and Adjustment Procedures

Initial Setup and Testing

Steps for turning on power, setting ON-TIME and RANGE controls for testing.

Sensor Aiming and Coverage

Instructions to adjust sensor head and range for optimal motion detection.

Time Delay Setting

How to set the duration the lights remain on after motion detection.

Troubleshooting and Support

Troubleshooting Common Issues

Lists common symptoms like light not coming on and their probable causes.

Technical Service and Warranty

Contact information for support and details on the limited warranty.