Heathkit IM-4180 - Page 10

== | Page 47
—_—
— ZZ
<< re
_
| ee
| | PSs SS a
———
oN ai eee
—
@
NT
gD) 1
| he Ne OI |
Lid je a ae |
| Wl | an a |
| ee | Su) 9 |
| ft | aa |
| 1) | | | Hel |
LMG) ae |B |
oO Tol,| Lassemauy_] | Ue |
LAS | | eo |
1 Hl | | ; | BLUE AND WHITE |
| Wl Len p TARE
| | | |
Ls | |
it | | _ | |
mice ee | |
aN 0 | |
rt Wek Ly o |
NBL IS, Be |
NT me |
oe es Lt : |
PICTORIAL 7-2 aw - | ty? : J
Refer
to
Pictorial
7-2
for
the
following
steps.
|
a
~w
|
Nl
xO
ra
(
A
Slide
the
bottom
front
edge
of
the
back
panel
Ne]
|
a“
assembly inside the bottom flange of the front Rx a | a
panel. Push it in until the mounting holes are . . gan
lined up. Start three 6-32 x 3/8” black phillips Gy #6 BLACK LOCKWASHER
head screws with #6 black lockwashers into the 6-32 x 3/8" BLAC
PHILLIPS HEAD SCREW
mounting holes.
ri
(' )} Start five more 6-32 x 3/8” black phillips head
screws with #6 black lockwashers through the the numbers on this label in any communica
ottom panel and into the circuit board spacers. tions you have with the Heath Company about
4 7 Oo . this kit.
(4) After all the bottom panel mounting screws a
have been started, tighten all of them securely. (eae Remove the paper backing from the four feet
and press one foot onto each corner of the bot-
( Yi Remove the paper backing from the blue and tom of the Meter as shown in the Pictorial.
white label and press the label in place on the o
rear panel as shown. NOTE: Be sure to refer ta { | HK Turn the Deviation Meter upright.