EasyManua.ls Logo

Heatmaster HM2-IPI-ECO - User Manual

Heatmaster HM2-IPI-ECO
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAREFULLY AND WITHOUT
ERROR OR FAILURE TO HEED ANY AND ALL WARNINGS IN THESE INSTRUCTIONS CAN
RESULT IN AN EXPLOSION, FIRE OR THE PRODUCTION OF CARBON MONOXIDE GAS
WHICH CAN CAUSE PROPERTY DAMAGE, BODILY INJURY OR DEATH.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use any telephone in your building.
Immediately call your gas supplier from a neighbor’s telephone.
Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the
gas supplier.
This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is in-
stalled. Provisions for adequate combustion and ventilation air must be provided. Refer to
page 4.
This appliance is intended for supplemental heating.
ANSI Z21.11 2-2016 APPROVED / ANSI Z21.60-2017 CSA 2.26 2017
State and local codes may only allow operation of this appliance in a vented configuration. Check your local and state codes.
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home,
where not prohibited by local codes. This appliance is only for use with the type of gas indicated on
the rating plate.
If the information in this manual is not followed exactly, a fire or explosion may result,
causing property damage, personal injury or loss of life.
WARNING
IM-149
10/2018
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
Installation and Operating Instructions for Natural & LP Gas
Unvented Gas Log Heater
HM2-IPI-ECO and HM2-MIL
18", 24" and 30/33" BURNER UNITS.
IMPORTANT: READ INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTAL-
LATION OF THIS ROOM HEATER.

Questions and Answers

  • K
    Kristen MorrowAug 13, 2025
    How to fix low battery power in Heatmaster HM2-IPI-ECO Indoor Fireplace remote?
    • J
      jonathanbellAug 13, 2025
      If your Heatmaster Indoor Fireplace remote has low battery power, the batteries are likely weak and need to be replaced.
  • K
    Kenneth JenningsAug 17, 2025
    What to do if Heatmaster HM2-IPI-ECO Indoor Fireplace module beeps constantly?
    • W
      Willie RogersAug 17, 2025
      If your Heatmaster Indoor Fireplace module beeps constantly, it could be due to a system cycle off and back on within 30 seconds. To resolve this, cycle the system to off and wait 30 seconds before relighting. Another potential cause is a loose ground wire, so ensure that the ground wire is tight.
  • J
    Jennifer LambertAug 21, 2025
    Why is there smoke and odor coming from my new Heatmaster HM2-IPI-ECO?
    • D
      Dana FriedmanAug 21, 2025
      The slight smoke or odor during the initial operation of your Heatmaster Indoor Fireplace is likely due to residues from manufacturing processes and logs curing. This issue should resolve itself after a few hours of use.
  • D
    Diane ColemanAug 26, 2025
    What does it mean when my Heatmaster HM2-IPI-ECO module beeps 4 times?
    • K
      kristen49Aug 26, 2025
      If the module of your Heatmaster Indoor Fireplace beeps 4 times every 2 seconds, it indicates that the module's internal temperature has exceeded 170 degrees. To fix this, cycle the system to off and allow the module to cool below 160 degrees.
  • T
    Tammy SheltonAug 29, 2025
    What does it mean when Heatmaster Indoor Fireplace module beeps twice per second?
    • J
      Juan BakerAug 30, 2025
      If your Heatmaster Indoor Fireplace module beeps twice per second, the pilot has likely been proven and then lost up to 3 times without being reset. The module will beep for 5 minutes. Place the switch in the off position once the beeping has stopped, then reset it to on.
  • M
    Michael StevensSep 2, 2025
    Why is my Heatmaster Indoor Fireplace beeping once per second?
    • A
      Amber WeaverSep 3, 2025
      If the module of your Heatmaster Indoor Fireplace beeps once per second, it indicates that the pilot did not light within the trial period. To resolve this, cycle the on/off switch or remote to off, then reset to on.
  • K
    Kimberly WestNov 7, 2025
    Why is the pilot sparking but not igniting on my Heatmaster HM2-IPI-ECO Indoor Fireplace?
    • T
      Tamara AndersonNov 7, 2025
      If the pilot sparks but doesn't ignite on your Heatmaster Indoor Fireplace, several factors could be at play. First, ensure the gas supply is on and the equipment shutoff valve is open. Air in the gas lines can also prevent ignition; try turning the burner system on and off repeatedly to remove the air, which may take several attempts. Check the thermocouple connections at both the control valve (hand tight plus 1/4 to 1/2 turn) and the control module. Also, verify gas flow to the ODS pilot and ensure all shut-off valves are open, checking that the pressure supplied to the valve is correct. A depleted LP gas supply or a disconnected/broken valve cable could also be the cause, ensure that the valve cable is correctly connected. The ODS pilot might be clogged, in which case you should clean ...

Heatmaster HM2-IPI-ECO Specifications

General IconGeneral
CategoryIndoor Fireplace
ModelHM2-IPI-ECO
Fuel TypeNatural Gas or Propane
Efficiency85%
Ignition TypeElectronic
Vent TypeDirect Vent
Ignition SystemIPI (Intermittent Pilot Ignition)

Related product manuals