Hebei CCT-3300 - Settings; Mode settings

5
Ⅲ．Settings
Please enter into the setting mode to check and set the relative parameters for
your first use. These parameters are in different menus.
The starting time for this instrument is about 10 seconds and the measurement
data during this time is invalid.
Front view
Two operation modes for CCT-3300 series：
◆
measurement mode：normal display/transient display
◆
setting mode：for parameter setting
switch diagram：
Select key
1. select thousand, hundred ,ten and unit in circulate under
parameter setting interface
2. switch to display conductivity/TDS/resistivity under
measurement condition
Add key
1. Adjust the value under parameter setting status.
2. Check the temperature/mA reading under measurement
status.
Enter key
1.Enter parameter setting under main menu
2.Save the parameters and enter next menu