Need help?Do you have a question about the HEDBOX UNIX and is the answer not in the manual?
Unscrew the four outer 2x4mm screws (A) to begin disassembly.
Carefully detach the metal back plate from the UNIX body.
Identify the three screws (B) on the internal USB PCB board.
Unscrew the three (B 1.5x3mm) screws and remove the internal USB PCB.
Locate, remove the old fuse, and install a new fuse (T10A, 250V).
Reattach the internal PCB and metal back plate, securing with original screws.
General| Brand | HEDBOX |
|---|---|
| Model | UNIX |
| Category | Portable Generator |
| Language | English |
To Next Page