Need help?Do you have a question about the HEIDENHAIN TNC 415 and is the answer not in the manual?
General| Brand | HEIDENHAIN |
|---|---|
| Model | TNC 415 |
| Category | Switch |
| Language | English |
Specifies the required PC and monitor hardware for the programming station setup.
Lists all included components for the HEIDENHAIN TNC 415 Programming Station.
Instructions for copying the programming station software from the provided floppy disk to the PC.
Details on configuring the monitor switchover card's port address using jumper settings.
Step-by-step guide for physically installing the monitor switchover card and connecting cables.
Instructions for connecting the power supply and ensuring correct operating voltage for the system components.
Guide on using the 'crtcfg' program and monitor controls to center the TNC image.
Process for transferring machine-specific parameters to customize the programming station.
Explanation of PP.EXE, PPCOM1.BAT, and PPCOM2.BAT files for initiating the programming station.
Details the specific commands and parameters used within the PPCOM batch files.
Procedure for launching the programming station software using the prepared batch files.
Instructions for toggling between the PC display and the TNC display during operation.
Steps to properly exit the programming station software and resume normal PC operation.
Guide for transferring part programs between the PC and the LE 415 L logic unit.
Instructions on how to transfer part programs between the PC and the machine tool.
To Next Page
