HEIL DuraPack 5000 2017 - Page 95

Issued September 2017
Daily Checklist
Copyright 2017, Heil Environmental
Printed in U.S.A.
87
DuraPack
®
5000
CHECKS AND INSPECTIONS
INSPECTION
RESULTS CODE
INSPECT PER APPLICABLE MANUFACTURER MANUAL
Cab/Drive
Wheels and Tires
Tractor and Chassis Electrical
Chassis
Engine & Transmission & Fluid Levels
Chassis Lubrication
REFUSE COLLECTION SYSTEMS AND COMPONENTS
CAB OUTSIDE AREA
Check air pressure of tires. Add air to any tire with air pressure lower than recommended before going on route.
Check wear of tire tread. Replace tire worn below tire manufacturer’s recommendation or state requirement before
going on route.
Check tires for damage. Replace any damaged tire before going on route.
Inspect pump for leaks.
Inspect pump for damage or loose hardware.
Inspect all decals on cab for damage and readability.
Inspect unit for refuse on or about the engine or exhaust components. Remove all refuse to prevent a fire.
BODY AND CHASSIS CURB SIDE INSPECTION