Heiniger saphir User Manual (English)

Other manuals for Heiniger saphir

Instructions21 pages

Instruction Manual220 pages

Manual17 pages

Questions and Answers:

S
Stephanie LawsonSep 6, 2025
Why is my Heiniger Commercial Food Equipment clipper cutting badly?
- Z
  Zachary CardenasSep 6, 2025
  Several factors can cause your Heiniger Commercial Food Equipment clipper to cut badly or not at all. The clipper blade might be blunt, requiring resharpening by a service center. The clipper blades may not have been correctly ground. Ensure the clipper blades are oiled every 15 minutes. Only clip dry hair. Hairs jammed between the top and bottom blades can be removed by taking off the clipperhead, pushing the top blade half away from the clipperhead, and removing the hairs. Finally, the clipperhead might have too little clipping pressure, requiring inspection.
T
Theresa RamirezSep 5, 2025
What to do if Heiniger Commercial Food Equipment motor is not running?
- C
  Clayton JohnsonSep 5, 2025
  If the motor of your Heiniger Commercial Food Equipment is not running, there are several possible causes. The battery may be dead, in which case you should charge it. The contacts might be dirty, so switch the clipper off and clean the contacts. The battery could also be faulty, requiring a replacement. Finally, a burning smell from the motor housing indicates a burned-out motor, which means you should have the motor and/or electronics replaced.
S
Stephanie CampbellSep 4, 2025
Why is my Heiniger Electric Shaver motor running very slowly?
- B
  barbermichelleSep 5, 2025
  If your Heiniger Electric Shaver motor runs very slowly, it might be because the clipper blades were not oiled sufficiently. Make sure to oil the clipper blades.
I
imartinAug 23, 2025
What to do if Heiniger Commercial Food Equipment top blade does not move?
- V
  Vanessa SpencerAug 23, 2025
  If the top blade of your Heiniger Commercial Food Equipment does not move, it could be that the clipperhead is not well engaged; engage the clipperhead correctly when the motor is running. Alternatively, the turning lever may be defective, requiring replacement.
L
Lee MartinezSep 3, 2025
What to do if the Heiniger Electric Shaver light doesn't change from green to red when the battery is unloaded?
- H
  Howard AllenSep 3, 2025
  If the light on your Heiniger Electric Shaver doesn't change from green to red when the battery is unloaded, the contacts might be dirty (clean contacts), the battery could be faulty (replace battery), or the contacts of the charging station are deformed (have the charging station repaired).
K
Kimberly MillerSep 2, 2025
How to fix a Heiniger Electric Shaver when the top blade does not move?
- T
  Tony HallSep 2, 2025
  If the top blade of your Heiniger Electric Shaver isn't moving, it could be because the clipperhead isn't properly engaged (engage the clipperhead correctly when the motor is running) or the drive carrier is defective (replace drive carrier).
M
Mark Cooper Jr.Sep 1, 2025
Why does the Heiniger Electric Shaver battery run time is too short?
- H
  Holly LivingstonSep 1, 2025
  If the running time of your Heiniger Electric Shaver's fully charged battery is too short, and/or the blades are getting hot, it could be due to insufficient oiling of the clipper blades (oil clipper blades) or the use of a flat, not fully charged, or faulty battery (only use intact, fully charged original batteries).
M
Michael LinAug 31, 2025
What to do if my Heiniger Electric Shaver cuts badly or not at all?
- R
  Ronald PowellAug 31, 2025
  If your Heiniger Electric Shaver is not cutting well, it could be due to several reasons. The clipper blade may be blunt and need resharpening by a service center. Ensure the clipper blades are oiled every 15 minutes. Only clip dry hair, as wet hair can affect performance. Hairs jammed between the top and bottom blades can also cause this issue; remove the clipperhead, push the top blade half away from the clipperhead, and clear any hairs. Finally, the clipperhead may have too little clipping pressure, requiring inspection by a service center.
S
stephanie15Aug 30, 2025
Why is my Heiniger Electric Shaver motor not running?
- K
  Karen WalkerAug 30, 2025
  The motor of your Heiniger Electric Shaver might not be running due to several reasons: the battery could be flat (charge the battery), the contacts might be dirty (switch the clipper off and clean the contacts), the battery could be faulty (replace the battery), there could be a smell of burning from the motor housing indicating a burned-out motor (have the motor and/or electronics replaced), the motor and/or electronics could be faulty (have the motor and/or electronics replaced), or the clipperhead could be blocked (clean and oil the clipperhead).
A
April GutierrezAug 29, 2025
How to fix a Heiniger saphir Hair Clipper when the top blade does not move?
- R
  Robert SpearsAug 29, 2025
  If the top blade of your Heiniger Hair Clipper does not move, it might be because the clipperhead is not well engaged. Ensure you correctly engage the clipperhead while the motor is running. Alternatively, the turning lever could be defective and needs replacement.