SILENCE FP BUTTON
Active/Disable SILENCE function. If pushing more than 2 seconds, the FP function will be
activated, pushing more than 2 seconds again to disable.
When the Silence function is activated, the compressor will operate at low frequency and
the indoor unit will bring faint breeze, which will reduce the noise to the lowest level and
creat a quiet and comfortable room for you. Due to low frequency operation of
compressor, it may result in insufficient cooling and heating capacity.
The FP function can only be activated during the heating operation (only when the setting
mode is HEAT). The unit will operate at a setting temperature of 8OC.The display window
of indoor unit will display FP. Press the buttons of ON/OFF, SLEEP, FP, MODE, FAN
SPEED,UP or DOWN while operating will cancel the FP function.
TIMER ON Button
Press this button to initiate the auto-on time sequence. Each press will increase the auto-
timed setting in 30 minutes increments. When the setting time displays 10.0, each press
will increase the autotimed setting 60 minutes increments. To cancel the auto-timed
program, simply adjust the auto-on time to 0.0.
TIMER OFF Button
Press this button to initiate the auto-off time sequence. Each press will increase the auto
-timed setting in 30 minutes increments. When the setting time displays 10.0, each press
will increase the auto-timed setting 60 minutes increments. To cancel the autotimed
program, simply adjust the auto-off time to 0.0/
SWING Button
Used to stop or start horizontal louver auto swing feature.
DIRECT Button
Used to change the louver movement and set the desired up/down air flow direction.
The louver changes 6O in angle for each press.
FOLLOW ME Button
Push this button to initiate the Follow Me feature, the remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes interval until press the Follow Me button again. The air conditioner will
cancel the Follow Me feature automatically if it does not receive the signal during any 7
minutes interval.
LED Button
Disable/Active indoor screen Display. When pushing the button, the indoor screen display
is cleared, press it again to light the display.
To Next Page
Loading...
Need help?
General
