AUTO OPERATION
Ensure the unit is plugged in and power is available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the desired temperature. The temperature can be
set within a range of 17⁰C~ 30⁰C in 1⁰C increments.
3. Press the ON/OFF button to start the air conditioner.
NOTE
1. In the Auto mode, the air conditioner can logically choose the mode of Cooling, Fan,
and Heating by sensing the difference between the actual ambient room temperature
and the setting temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed. It has already been automatically
controlled.
3. If the Auto mode is not comfortable for you, the desired mode can be selected
manually.
Cooling /Heating/Fan operation
Ensure the unit is plugged in and power is available.
1. Press the MODE button to select COOL, HEAT (cooling & heating models only) or FAN
mode.
2. Press the UP/DOWN buttons to set the desired temperature. The temperature can be
set within a range of 17⁰C~ 30⁰C in 1⁰C increments.
3. Press the FAN button to select the fan speed in four steps- Auto, Low, Med, or High.
4. Press the ON/OFF button to start the air conditioner.
NOTE
In the FAN mode, the setting temperature is not displayed in the remote controller and
you are not able to control the room temperature either. In this case, only step 1, 3 and 4
may be performed.
Dehumidifying operation
Ensure the unit is plugged in and power is available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the desired temperature. The temperature can be
set within a range of 17⁰C~ 30⁰C in 1⁰C increments.
3. Press the ON/OFF button to start the air conditioner.
NOTE
In the Dehumidifying mode, you can not switch the fan speed. It has already been
automatically controlled.
V. HOW TO USE THE BUTTONS
To Next Page
Loading...
Need help?
General
