www.heinner.com 8Kg, 220-240V~50Hz
14
You should operate the dryer to full capacity, but make sure that it is not overloaded.
• When the laundry is being washed, the spin speed should be at the highest level possible. This will
shorten the drying time and reduce energy consumption.
• Make sure that the same kinds of laundry are dried together.
• Please follow the recommendations in the user manual for programme selection.
• For air circulation, leave an appropriate clearance on the front and back sides of the Dryer. Do not cover
the grills on the front side of the machine.
• Unless necessary, do not open the door of the machine when drying. If you have to open it, do not keep
it open for a long time.
• Do not add new (wet) laundry during the drying process.
• Hairs and lint that detach from the laundry and merge in the air are collected by the "Lint Filters". Please
make sure that the filters are cleaned before and after each use.
• For models with a condenser, make sure that the condenser is cleaned at least once a month or after
each 15 uses.
• During the drying process, the environment where the dryer is installed must be well ventilated.
Your tumble dryer is equipped with a built-in fault detection system, indicated by a combination
of flashing operation lights. The most common failure codes are shown below.
Empty the water tank, if problem does not solved, contact the
nearest authorised service agent.
Contact the nearest authorised service agent.
Contact the nearest authorised service agent.
Contact the nearest authorised service agent.
There may be voltage fluctuation in mains.Wait until voltage is
appropriate for working range.
To Next Page
Loading...
Need help?
General
