www.heinner.com ϴϬϬͲϵϱϬt, 50Hz, 220-240V
6
USING YOUR COFFEE MAKER
1. Plug the power cord into the outlet. The LCD display indicates “12:00”.
2. Press ON/OFF button, the LED illuminates in red, and then the appliance begins to work.
Note: The brewing process can be interrupted by pressing the ON/OFF button at any time,
and the LED will extinguish, indicating your coffee maker is power off.
Note: During brewing process, the buttons of “PROG”, “HR” and “MIN” are invalid.
3. When the pr ocess is finished, if you do not want to serve immediately, keep the coff e e
maker is energized, the coff ee can be kept warm in the k eep warm plate and the appliance
will be cut off automatically after kee ping warm for 40 minutes. For an optimum coffee taste,
serve it just after brewing.
4. Always turn the coffee maker off and disconnect the power supply when not use.
DELAY FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is
8:10, you hope that the coffee maker will automatically start working at 1:00, first follow
steps 1 to 5 of above section, and then you can set the automatic start function as follows :
1) Press PROG button one time, that is 8:10 (See Fig. 1).
Note: The time cycle is 24 hours.
2) Press PROG button one time, the LED will illuminates in blue and flash. (means the
coffee make enter the presetting time state.)
3) Set the delayed starting time by pressing HR and MIN button repetitively, that is 01:00
(see Fig. 2).
4) Press the ON/OFF twice, the LED is illuminated in blue. After a while, the LCD will display
the current clock. You may see the automatic start time by pressing PROG.
Note: You may cancel the automatic start function by pressing ON/OFF. If you want to change
the automatic start time, only following the above 2-4 steps again.
5) When the time is due, the LED will illuminate in red and the appliance starts brewing.
When the process is finished, if you do not want to serve immediately, keep the coffee mak er
is energized, the coffee can be kep t warm in the keep warm plate and the appliance will be
cut off automatically after keeping warm for 40 minutes. For an optimum coffee taste, serve
it just after brewing.
Note: During brewing process, the buttons of “PROG”, “HR” and “MIN” are invalid.
To Next Page
Loading...
Need help?
General
