www.heinner.com ϴϬϬͲϵϱϬt, 50Hz, 220-240V
7
CAUTION: Be sure to unplug this appliance before cleaning. To protect against
electrical shock, do not immerse cord, plug or unit in water or liquid. After each use,
always make sure plug is first removed from wall outlet.
1. Clean all detachable parts after each use in hot sudsy water.
2. Wipe the exterior surface of unit with a soft, damp cloth to remove stains.
3. Water dr oplets may buildup in the above area of the funnel and drip onto the
product base during brewing. To control the dripping, wipe off the area with a clean,
dry cloth after each use.
4. Use a damp cloth to gently wipe the keeping warm plate. Never use abrasive cleaner
to clean it.
5. Replace all parts and keep for next use.
REMOVING MINERAL DEPOSITS
To keep your coffee maker operating efficiently, periodically you should clean away the
mineral deposits left by the water according to the water quality in your area and the
use frequency, we recommend removing mineral deposits as follows :
1. Fill the tank with water and descaler to the max level as indicated on water gauge
(the scale of water and descaler is 4:1, the detail refer s to the instruction of descaler.
Please use “household descaler”, you may also use the citric acid instead of the
descaler (the one hundred parts of water and three parts of citric acid).
2. place the serving cup under the brew basket.
3. Make ensure funnel are assembled in place.
4. Switch on the appliance and allow it to “brew” de-scaling solution.
5. After “brew” one-cup solution, switch off the appliance.
6. Leave the solution stay for 15 minutes and repeat step 3-5.
7. Switch on the appliance and run off the solution until the water tank is completely
empty.
8. Rinse by operating the appliance with water at least 3 times.
VII. CLEANING AND MENTENANCE
To Next Page
Loading...
Need help?
General
