5. Timer Pad
Press to initiate the Auto start and Auto stop feature, in conjuction with the + and -
key pads.
6. Turbo Pad
Control the fan speed. Press to select either High or Normal fan speed. Set the fan
control to High for maximum moisture removal. When the humidity has been reduced
and quiet operation is preferred, set the fan control to Normal.
7. Ion Pad(optional)
Press to activate the ionizer. Anions ar automatically generated by ionization. The anions
deactive the airborne chemical vapors and dust particles. Press it again to stop the
function.
8. Display
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while
setting, then shows the actual ( ± 5% accuracy) room % humidity level in a range of
RH(Relative Humidity) to 90%RH(Relative Humidity). Error Codes and Protection Codes:
AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for
service. ES- Temperature sensor error-- Unplug the unit and plug it back in. If error
repeats, call for service.
P1- Unit is defrosting-- Allow the unit time to automatically defrost. The protection will
clear after the unit self defrosts.
P2- Bucket is full or bucket is not in right position—Empty the bucket and replace it in
the right position.
E3- Unit malfunction-- Unplug the unit and plug it back in. If error repeats, call for
service.
EC- Refrigerant leakage detection-- With this new technology, the display area will
appear EC when the unit detects refrigerant leakage, call for service.
To Next Page
Loading...
