Instructions on humidification function
• Remove the water tank from the host and unscrew the water tank cap
counterclockwise.
• Fill the water tank with cold water, tighten the water tank cap and check for
leakage.
• As is shown, put the water tank into the host according to the angle, and wait a
few minutes until the host sink is filled with water.
• After the humidification button is pressed, the indicator lights up to start
humidification.
Note: If the indicator flashes (off after 10 seconds), it indicates insufficient water or
low water level, please check whether the float in the sink of the host has floated or
the water tank is properly placed.
PRECAUTIONS
• Before use, please check that the machine has been assembled completely and
fixed motor components have been mounted and fastened; before this, do not
connect the power supply.
• Before turning on the power, check whether the used voltage is the same as the
voltage indicated on the machine.
• When the appliance works, do not insert your fingers and sharp objects into the
guard or the machine body.
• Children shall use this electric appliance under adult supervision to prevent
accidents. When using an electric mosquito repellant, please ensure that it is out of
reach by children, and if it is accidentally swallowed, seek medical attention
immediately.
To Next Page
Loading...
Need help?
General
