• Prior to use, check the power cord and plug for any damage, and if the power cord
is damaged, in order to avoid danger, be sure to have it replaced by the manufacturer,
maintenance department or professionals with the similar qualification.
• If the appliance is left unattended or is no longer in use, turn off the power and
unplug the power cord to avoid failure problems and accidents.
• When the humidifier is used, the water tank shall use clean water below 40°, and it
is recommended to use demineralized water, pure water or distilled water containing
less impurities.
• Do not place this appliance on sloping ground to avoid tipping over, and do not
move the water tank when the humidifier is working; if the humidifier or host
accidentally tips over when it contains water, please unplug the power cord and remove
the water tank in the machine body, and reuse it after there is no hidden security risk in
the machine and especially no water accumulates in the machine body.
• When using a humidifier, you cannot add sanitizers, vinegar, perfume or essential
oils.
• When using a humidifier, never have the mist to face the furniture, appliances or
walls to avoid damage due to excessive damp.
• Water is inside the water tank or sink shall not be placed for a too long time, as this
may easily breed bacteria; change the water every 2 days and clean the sink once every
2-3 weeks.
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified
service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free
of dust. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface. Do not
use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thoroughly
remove soap film with dry cloth.
1.
To Next Page
Loading...
Need help?
General
