www.heinner.com 5Kg, 220-240V~50Hz, 800rpm
36
Spinning operation is
not performed or runs
late.
No fault. Unbalanced load
control system has been
activated.
Unbalanced load control system will try
to spread your laundries
homogenously. Spinning operation will
begin after your laundry is spread.
Place the laundry in the machine in a
balanced fashion the next time.
Your machine is equipped with the systems which are capable of both taking necessary
precautions and warning you in case of any breakdown by means of continuous self-checking
during washing operations.
The door of your machine is
left open
Close the machine door. If your
machine persists to indicate fault,
turn off your machine, unplug it and
contact the nearest authorised
service immediately.
The water pressure or the
water level inside the
machine is low
Turn on the faucet. Mains water may
be cut-off. If the problem still
continues, your machine will stop
after a while automatically. Unplug
the machine, turn off your faucet
and contact the nearest authorised
service.
The pump is faulty or pump
filter is clogged or lecetrical
connection of the pump is
faulty
Clean the pump filter. If the problem
persists, contact the nearest
authorised service.
Your machine has excessive
amount of water
Your machine will discharge water
by itself. Pursuant to discharging
operation, turn off your machine
and unplug it. Turn off your faucet
and contact the nearest authorised
service.
XII. AUTOMATIC FAULT WARNINGS AND WHAT TO BE DONE
To Next Page
Loading...
Need help?
General
