Pag.5
• Wait or press button (B-4) to switch to automatic mode
• A sensor in the transmitter measures the room temperature. The controler compares the room temperature
with the set temperature and sends a signal to the receiver to turn the gas valve motor, which adjusts the
flame height accordingly.
Programming the timer
• Press button (B5) until P1* flashes ( period 1, heating cycle on ).
• Set the time for the beginning of the first heating period by pressing button (B-6)for hour and button (B-7)
for minute.
• Press button (B-5) again; P1) appears
• Set the time for the end of the first heating period.
• Press button (B-5) again to set the seccond heating period P2* ( heat on ) and P2) ( heat off )
• Store both heating periods by pressing button (B-5) again.
• If only one heating period is desired, program the same time for P2* and P2).
Manual mode ( MAN in display ) for manual flame height adjustment.
• Press button (B-6) to turn on the fire (main burner) or to increase flame height
• Press button (B-7) to decrease flame or to turn down the pilot.
• To incrementally increase or decrease the flame height lightly tap either the button (B-6) or button (B-7).
• The “send” symbol appears in the upper left corner of the display when either button is depressed.
• The Led of the receiver flashes when the knob (A2) of the valve reaches it end stops.
Automatic mode ( AUTO in display ) for temperature control.
• Briefly press button (B-4). The set temperature will appear briefly before the display reverts to the room
temperature.
Timer mode ( TIMER in display )
• During heating periods P1* and P2*, the temprature is controlled in the same manner as in the automatic
mode.
• When the timer program turns to ) (heating cycle off ), the motor will turn the valve to pilot and there is no
temperature control. This minimizes battery consumption.
• You may press button (B-4) to verify the set-temperature and then press button (B-5) to return to timer
mode.
• You may press either the (B-6) or (B-7) button from any mode for manual override.
• To prolong battery life, we recommend switching the transmitter to manual mode and turning the fire to
pilot with the (B-7) button before turning the appliance off. If the transmitter is left in automatic or timer
mode, the batteries will continue to be used when the appliance is off.
Changing the battery
• Iff BAT appears in upper right hand corner of the disply or if the LED of the receiver becomes faint, please
change the battery from transmitter or receiver. If the batteries loose power, the flame height can be
adjusted by manually turning knob (A2).
Note
Please note, the placement of the transmitter ( temperature sensor ) is important to assure proper tempera-
ture regulation.. Generally, a more constant temperature wil be assured, if the transmitter is not to far from
the gas appliance. Before switching to Auto (B-4) or Timer (B-5) mode, press either button (B-6) or (B-7)
to verify the reception ( when the send symbol appears in the transmitter display the receiver’s LED must
illumenate). For the Auto or Timer mode to function correctly, the transmitter must remain within range of
receiver. The transmitter should not be used in very close proximity to the receiver ( les than 1mtr / 3ft ) as
this could, in very rare cases, produce an electronic switching error. This error could block the motor when
the knob reaches the end points of its turning radius. The knob must then be turned manually to free the
blockage.
To Next Page
Loading...