Fig. 4-5 Inching valve
4.5 Transmission Case
It is used to contain the input shaft, the output shaft, etc. and serve as an oil tank.
There is an oil filter (I) of 150 meshes in specification at the bottom of the case to
filter the oil from the charging pump. The oil filter (II) for the pipeline, the oil inlet
cover and the dip stick are all fixed at the top of the case cover.
4.6 Charging Pump (See Fig.4-6)
The charging pump between the torque converter and the input shaft of the
transmission is a gear pump driven by the turbine shaft concluding a pair of inner-
meshed gears for the purpose of feeding the oil to the torque converter and the
transmission.
(1)Snap ring
(2) O-ring
(3) Inching valve rod
(4) Snap ring
(5) Spring
(6) Valve core
(7) Spool
(8) Valve body
(9) Spring
(10) O-ring
(11) Cover
(12) Oil seal
-37-
To Next Page
Loading...
Need help?
General
