completely under the cargo and make the cargo placed on it evenly. Do not raise an object
completely under the cargo and make the cargo placed on it evenly. Do not raise an object
with one fork end.with one fork end.
(5) The starting, turning, driving, braking and stopping operation (5) The starting, turning, driving, braking and stopping operation of the truck shouldof the truck should
be done smoothly. When steering on the humid or low friction road, the truck should bebe done smoothly. When steering on the humid or low friction road, the truck should be
decelerated.decelerated.
(6) Travel with loads as low as (6) Travel with loads as low as possible and tilted backwapossible and tilted backward.rd.
(7) Be careful when traveling on a (7) Be careful when traveling on a slope. When climbing grades with a slope of moreslope. When climbing grades with a slope of more
than 10%, the truck should forward travel, and when descending so grades, backwardthan 10%, the truck should forward travel, and when descending so grades, backward
travel. Never turning on a slope. Avoid loading and unloading operation when decending.travel. Never turning on a slope. Avoid loading and unloading operation when decending.
(8) Pay attention to pedestrian, obstacle and bumpy (8) Pay attention to pedestrian, obstacle and bumpy road when driving. Pay attentionroad when driving. Pay attention
to the clearance over forklift truck.to the clearance over forklift truck.
(9) Never allow any pers(9) Never allow any persons to stand on the forks or the truck to carry persons.ons to stand on the forks or the truck to carry persons.
(10) Never permit anyone to stand or walk under upraised forks.(10) Never permit anyone to stand or walk under upraised forks.
(11) Don’t (11) Don’t operate trucoperate truck and attachment of it at any positiok and attachment of it at any position out of the drive seat.n out of the drive seat.
(12) On the high lift forklift truck, when the lift high more than 3m, it is noted that the(12) On the high lift forklift truck, when the lift high more than 3m, it is noted that the
goods on it should not fall down or the protectgoods on it should not fall down or the protection measures must be taken if necesion measures must be taken if necessary.sary.
(13) Tilt the mast of the high lift forklift truck as backward as possible while the truck(13) Tilt the mast of the high lift forklift truck as backward as possible while the truck
workingworking. Use minimum forward tilt angle and Min. reverse tilt when loading and unloading.. Use minimum forward tilt angle and Min. reverse tilt when loading and unloading.
(14) Be careful and slowly driving over a dockboard or bridge-pl(14) Be careful and slowly driving over a dockboard or bridge-plate.ate.
(15) Shut down the en(15) Shut down the engine and don’t stay on the truck when fillingine and don’t stay on the truck when filling fuel. Don’t igniteg fuel. Don’t ignite
the engine while checking battery or fuel lever.the engine while checking battery or fuel lever.
(16) The unloaded forklift truck with attachments should be operated as a loaded(16) The unloaded forklift truck with attachments should be operated as a loaded
truck.truck.
(17) Don’t (17) Don’t handle unfixehandle unfixed stacked goods.Bd stacked goods.Be careful to bulky goods to be handled.e careful to bulky goods to be handled.
(18) If leaving the truc(18) If leaving the truck, lower the forks on the ground and let the shift lever to neutrak, lower the forks on the ground and let the shift lever to neutral,l,
shut down the engine or cut down electric supply. If parking on a slope is unavoidable,shut down the engine or cut down electric supply. If parking on a slope is unavoidable,
apply the parking brake and block the wheels.apply the parking brake and block the wheels.
(19) Don’t (19) Don’t open the radiatoopen the radiator cap when the engine is worm.r cap when the engine is worm.
(20) Don’t adjust the control valve and relief valve at will to prevent the (20) Don’t adjust the control valve and relief valve at will to prevent the damage ofdamage of
hydraulic system and its components because of excessive pressure passing them.hydraulic system and its components because of excessive pressure passing them.
(21) According to the measure method specified in JB/T3300,max.noise at the(21) According to the measure method specified in JB/T3300,max.noise at the
outboaroutboard of the d of the truck should be not more than 89dB(A).truck should be not more than 89dB(A).
(22) Notice and be famil(22) Notice and be familiar with all kinds of decal’s iar with all kinds of decal’s functionfunction..
-2-2 --
To Next Page
Loading...
Need help?
General
