What to do if Helion AURA 650 Toy system is not connected?
If your Helion Toy system isn't connecting, the issue might be due to several reasons. First, the transmitter and receiver could be too close; try separating them by 1 to 3 meters. Metal objects nearby can also interfere with the connection, so move to an area with fewer metal objects. Lastly, ensure the receiver is properly paired with the transmitter by repeating the pairing process.
Why is my Helion AURA 650 Toy receiver not responding to the transmitter?
If your Helion Toy receiver isn't responding, there are a couple of things to check. It could be due to low battery voltage, so try replacing the batteries with new ones. Also, inspect the wires and connections between the batteries and the receiver for any looseness or damage. Repair or replace any faulty wires or connectors.
Setup the display base by inserting tubes into sockets without glue.
Attach keel, rubber piece, and ballast using HM 5x25mm screw and 4.0mm allen key.
Secure keel and rubber piece to hull using HM 5x50mm screw and 4.0mm allen key.
Insert rudder through hull, connect to rudder arm, and tighten screw.
Adjust silicone rings on main boom for sail tension and boom center position.
Adjust jib boom rigging for sail tension, jib angle, and boom position relative to mast.
Adjust jib boom counterweight for neutral balance and equal movement.
To Next Page
General
