15
remote input (Rem In) must be connected to
the radio remote output if the processors pre-
amplier inputs are used as signal inputs. We
do not recommend controlling the remote input
via the switched ignition wire in order to avoid
interference and shutdowns. If the high level in-
puts are used this cable does not neeed to be
connected. In such case make sure the cable is
well insulated and does not make any contact
with vehicle ground.
4. Connecting the remote output
This output is used to supply remote signals to
the amplier/s. Please use always this remote
output signal for switching the amplier/s on to
avoid on/off switching noises.
Once you have double-checked the wiring, con-
nect the terminals for the power supply and op-
tionally the highlevel terminal / RCA cables to
the C-DSP.
To Next Page
Loading...
Need help?
General