Bluetooth Splitter Function (Transmitter Mode Only)
1. Refer to the Transmitter Instructions above to first connect Bluetooth Device A
(speaker/headphones).
2. After the Device A is successfully connected, turn on the Bluetooth Device B
(speaker/headphones) and place into pairing mode.
3. Double click to enter pairing mode. to enter pairing mode. “TX”
will begin flashing.
4. FlyWireless will start searching for Device B and will automatically connect after
a few moments.
5. After the connection is successful, the “A” and “B” indicators will both turn on. You
should hear audio from both devices at the same time.
Receiver Instructions
1. Press and hold for 3 seconds to power on.
2. Switch on side of unit to “RX”position. “RX” indicator will turn on.
3. Insert the 3.5mm audio cable into the 3.5mm audio port of the FlyWireless, and insert
the other end of the audio cable into the audio output device (speaker/headphones).
4. Double click to enter pairing mode. “RX” indicator will begin flashing.
5. Turn on the Bluetooth function of the mobile phone, scan for Bluetooth devices, and
select “FlyWireless” from the list of available devices.
6. After the connection is successful, the “A” indicator will turn on. You can now start
receiving audio.
NOTE: If pairing or audio fails for any of the above functions, turn off the FlyWireless
along with Bluetooth speakers/headphones. Then begin instructions again from Step 1.
2
English
To Next Page
Loading...
General