Important:
• After installing the inlet hoses, do not immediately switch on the power. Open the tap,
check both ends of the hose for water leakage.
• If the inlet hose is difficult to install or screw to the tap etc., we recommend you can call
experienced person to help.
• Both hoses must be connected, otherwise water may discharge from the unconnected
inlet.
WARNING:
PLEASE ENSURE THAT THE HOT WATER TAP IS CONNECTED TO THE HOT WATER
INLET AND THE COLD WATER TAP IS CONNECTED TO THE COLD WATER INLET OF
THE WASHING MACHINE.
Installation of drain hose
Squeeze the fixing ring with your fingers (or pliers) to
open over the flexible drain hose, place the flexible
drain hose over the inner hose located in the bottom
left side of the washing machine.
Note: If the flexible drain hose is tight and difficult to fit
to the inner hose, soak the head of the drain hose in
warm water prior to fitting to the inner hose.
Pass the fitting ring over the hose and fasten over the
connection by squeezing the ring with your fingers or
pliers.
Recommend the outlet of the drain hose be
permanently connected to a drainage connection or
securely fitted to a suitable sink or trough with overflow
outlet.
CAUTION: Do not place the washer outside, or in an open to the moisture area (rain, hosing,
pool, etc.), close to curtains, blinds, etc., or near gas supply or appliances, or in a flammable
area.
Important: Always operate the washer from a power source of the same Voltage, Frequency
and Rating, as indicated on the washing machine identification plate. Operate the Washing
Machine from an Earthed (Grounded) 3 pin power outlet fully accessible when the washing
machine is in its normal operating position.
WARNING: Avoid the use of extension cords and portable outlet devices. If it is necessary to
use an extension cord, or portable outlet device, prior to its use, make sure the extension cord
5
To Next Page
Loading...
Need help?
General
