OPERATING INSTRUCTIONS
POWER CONNECTION
This product operates on 120V~ 60Hz power supply. Plug the AC power cord into a
household outlet AC source. This unit is equipped with a battery back-up system,
requiring one DC3V “CR2032” type lithium battery (not included). Insert the battery
in the BATTERY COMPARTMENT (6), making certain that the positive and negative
(+ and -) sides are properly aligned. If an AC power failure occurs, the clock
automatically switches to the battery power supply, the clock and alarm time
memory continue running internally and the radio presets are preserved. When
power returns, the unit switches back to AC again.
NOTE: The display will not exhibit time during power failure but the clock will keep
correct time internally.
BATTERY CARE
Use only the size and type of batteries specified.
If the unit is not to be used for an extended period of time, remove the battery.
Old or leaking batteries can cause damage to the unit and may void the warranty.
Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture (Follow battery manufacturer’s directions).
Do not dispose of batteries in fire, batteries may leak or explode.
SETTING THE LED DIGITAL CLOCK
1. In standby mode, press and hold the SET MEM / M+ button (15), “12 Hr” will
blink. Press the (16) or (14) button to select the 12 hour (12 Hr) or 24 Hour
(24 Hr) format.
2. Press the SET MEM / M+ button (15) and the hours will blink. Press the (16)
or (14) to set the current hour.
3. Press the SET MEM / M+ (15) button again then the minutes will blink. Press the
(16) or (14) to set the current minute.
4. Press SET MEM / M+ (15) button once and the current time is set.
NOTE: THE LED DIGITAL CLOCK AND THE PROJECTION CLOCK MUST BE
SET SEPARATELY.
SETTING THE PROJECTION CLOCK
1. Set the PROJECTION ON/OFF button (13) to “ON”.
2. While holding the TIME button (11), keep depressing the HOUR button (10) to
quickly approach the desired hour. Then release and tap the HOUR button (10)
until the correct hour is displayed.
3. While holding the TIME button (11), keep depressing the MINUTE button (21) to
quickly approach the desired hour. Then release and tap the MINUTE button (21)
until the correct minute is displayed.
4. To turn the projection off, set PROJECTION ON/OFF button (13) to “OFF”.
FOCUS SETTING
To adjust the focus of the projection clock, turn the FOCUS ADJUSTOR (9) until the
projected time is clearly shown on the ceiling or wall.
To Next Page
Loading...
Need help?
General
