LISTENING TO THE RADIO
NOTE: Ensure that the FM wire antenna (17) is completely unrolled and extended
to have the best FM reception.
The AM band uses an internal, directional antenna. Rotate the entire radio
for best AM reception.
1. Press the ON/OFF / BAND button (12) to turn the unit ON.
2. Press the ON/OFF / BAND button again to select AM/FM band. When FM band
is selected, the FM FREQUENCY INDICATOR (22) will light.
3. Use the TUNE + (16) or TUNE – (14) button to select the desired radio station. If
you press and hold the TUNE + (16) or TUNE – (14) button for one second, then
release, the unit will automatically scan to the next broadcasting station.
4. The broadcasting radio frequency will be displayed for about 5 seconds before
reverting to the clock time.
5. Press & hold the ON/OFF button (12) for about 3 seconds to turn the radio OFF.
TO SET/RECALL RADIO PRESETS
1. Press the ON/OFF button (12) to turn the unit ON.
2. Press the ON/OFF / BAND button again to select AM/FM band. When FM band
is selected, the FM FREQUENCY INDICATOR (22) will light.
3. Use the (16) or (14) button to select the desired radio station.
4. Press and hold the SET MEM / M+ button (15); the next available preset
memory number will flash in the LED display. (Note: “P02” will blink in the
display if you are programming presets for the first time.)
5. Press the (16) or (14) button to change to the desired preset number P01
thru P10.
6. Press the SET MEM / M+ button (15) again to save the current radio station to
the desired memory preset that you selected.
7. Repeat steps #3 thru #6 to preset up to 10 stations for each AM and FM band.
8. To retrieve one of the preset stations already programmed, press SET MEM /
M+ button (15) until you reach the desired preset number/radio station.
RESETTING YOUR PROJECTION CLOCK RADIO
If the system does not respond or exhibits erratic or intermittent operation, you may
have experienced an electrostatic discharge (ESD) or a power surge that triggered
the internal microcontroller to shut down automatically. If this occurs, simply
disconnect the AC power cord and remove the system back-up battery, wait for at
least 3 minutes and then setup the unit again as if you were using it for the very first
time.
CARE AND MAINTENANCE
1. Clean the unit with a soft, damp (never wet) cloth. Solvent or detergent should
never be used.
2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places to
reduce the risk of fire or electric shock.
To Next Page
Loading...
