Helm C Series - Output Tags

20 HM1734-WM Strain Gage Input Module
Data Map for HM1734-WM on Ethernet/IP
OUTPUT TAGS
[n] = slot number for module
AENT_A:[n]:O.Data
SINT[4]
Description
Output_bits_mod1.0
bit
Set Cal Mode Bit
Output_bits_mod1.1
bit
Set Run Mode Bit
Output_bits_mod1.2
bit
Ch1 Clear Tare Bit (momentary)
Output_bits_mod1.3
bit
Ch1 Tare Bit (momentary)
Output_bits_mod1.4
bit
Reserved
Output_bits_mod1.5
bit
Read AD Trim Bit (Factory Use Only)
Output_bits_mod1.6
bit
Ch2 Clear Tare Bit (momentary)
Output_bits_mod1.7
bit
Ch2 Tare Bit (momentary)
Output_bits_mod1.8
bit
Reserved
Output_bits_mod1.9
bit
Set ch1_only
Output_bits_mod1.10
bit
Set_to_4ms (Frequency)
Output_bits_mod1.11
bit
Set_to_8ms (Frequency)
Output_bits_mod1.12
bit
Set_to_16ms (Frequency)
Output_bits_mod1.13
bit
Set_to_32ms (Frequency)
Output_bits_mod1.14
bit
Set_to_40ms (Frequency)
Output_bits_mod1.15
bit
Set_to_48ms (Frequency)
Output_bits_mod1.16
bit
Vibration Filter Bit
Output_bits_mod1.17
bit
Set Motion Stabilization Filter (MSF) range from -0.002% to +0.001% of full
scale
Output_bits_mod1.18
bit
Set Motion Stabilization Filter (MSF) range from -0.004% to +0.002% of full
scale
Output_bits_mod1.19
bit
Set Motion Stabilization Filter (MSF) range from -0.008% to +0.004% of full
scale
Output_bits_mod1.20
bit
Set Motion Stabilization Filter (MSF) range from -0.010% to +0.005% of full
scale
Output_bits_mod1.21
bit
Set Zero Dead Band to 0.025% of full scale
Output_bits_mod1.22
bit
Set Zero Dead Band to 0.05% of full scale
Output_bits_mod1.23
bit
Set Zero Dead Band to 0.075% of full scale
Output_bits_mod1.24
bit
Average Sample_bit0
Output_bits_mod1.25
bit
Average Sample_bit1
Output_bits_mod1.26
bit
Average Sample_bit2
Output_bits_mod1.27
bit
Average Sample_bit3
Output_bits_mod1.28
bit
Average Sample_bit4
Output_bits_mod1.29
bit
Average Sample_bit5
Output_bits_mod1.30
bit
Average Sample_bit6
Output_bits_mod1.31
bit
Average Sample_bit7