6
EN
Operation Instruction
How to brew coffee by our Percolator? Please
operate as the following:
1. Clean the filter basket, cover, percolator tube
and the inside of tank with a non-abrasive de-
tergent.
2. Pour cool water into the urn to bill at least half
of total capacity of the urn
3. Center the Percolator tube (10) into the bas-
ket tray (9), and make sure that the foot of the
tube is positioned firmly on the well of the urn.
4. Center the filter basket (8) into the Percolator
tube (10) and place the grounded coffee in the
basket than cover back with the basket cover
(7) and the cover of the urn (1)
5. Plug the cord into the electric outlet and turn
the power switch (5) “ON”.
6. When the indicator lamp (6) lights green, the
brewing process is completed.
7. The second heating system will start to op-
erate automatically to keep the coffee warm,
coffee now ready to be served.
8. When there are only about 3 cups of coffee
left in the urn, please turn the power switch
(5)”OFF”and unplug the cord from the electric
outlet.
9. Advice: use 500 grams of coarsely ground cof-
fee per 10 litres of water.
Do not touch the outside of the appliance during
use! IT IS HOT!!!
After use / Empty the boiler
• Turn off the appliance by switching off the
switch and removing the plug from the socket.
• Place a drip tray under the tap.
• Open the tap and drain the beverage out of the
boiler.
• When the boiler has been emptied, close the
tap.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents, abra-
sives or chlorinated cleaners. Do not use any
sharp or pointed objects. Do not use petrol or
solvents! Clean with a damp cloth and deter-
gent if necessary. Do not use abrasive mate-
rials.
• Clean and descale the bottom of the boiler at
regular intervals (see chapter “Descaling”).
• When you drain off beverage or dirty water,
leave the tap open and rinse the boiler with
clean water.
• Avoid water contacting the electrical compo-
nents.
To Next Page
Loading...
