Causes Solutions
If the water drip tray is full, any function
of making beverage will be out of service.
Take the drip tray out, empty the
waste water in the drip tray and
reinstall it to the machine.
If the coffee grounds container is full,
any function of making beverage
will be out of service.
Take the coffee grounds container
out, empty the coffee grounds
container and reinstall it.
If water in the water tank is used up,
any function of making beverage
will be out of servic
e.
Fill the water
tank with water.
If coffee beans in the bean container are
used up, function of making coffee
will be out of service.
Add beans into bean container,
and press the rotary button to release.
There is not enough coffee powder
in the powder container.
Next time when making coffee with coffee
powder, please put a full spoon of po
wde
r.
The drip tray is not installed correctly;
any function is out of service.
Install the drip tray correctly.
The water in the pipe inside the machine
is not enough; any function is out of
service.
Press the rotary button to release,
to run the water replenishing system.
Temperature of the machine is too high,
the machine cannot be used.
Power off the main power, and use
it 1 hour later.
Temperature of the machine is too l
ow
,
the machine cannot be used.
Increase environmental temperature
to above 10°C.
The coffee machine failures,
may not be able to be used.
1. Power off, restarting up；2. If still
unresolved, please pull out the plug.
Contact with customer sevice center.
1. Using dark roasted coffee beans
or over fine coffee powder;
2. The filter of the brewer is clogged.
1. Adjust grinder wheel to rougher;
2.
Start
brewer cleaning procedure
(refer to P17).
Dispenser valve is blocked. Restart coffee machine.
9. DISPLAY INFORMATION
•
This chapter will instruct you the information shows on the screen
and the solutions.
25
EN
To Next Page
Loading...
